Pixel 6, The renders are made by PBK reviews, and while the interiors of the Pixel 6 and Pixel Pro are almost identical, there are some notable differences from the lighter videos. PBK reviews say the Pixel 6 and Pixel Pro use more heat behind and below the screen.

The Pixel Pro and Pixel phones are often unlocked to show off their interior and capabilities. Both phones are loaded with maximum heat spread and also display the TearDown 2000 View layout. The videos are mostly based on the specs of the two phones and both the screen and the fingerprint sensor work well after the change.

Pixel 6 and Pixel 6 Pro Specification:

• PBK Reviews has published two pages commenting on Pixel 6 and Pixel Pro Uninstallation.
• After turning on both phones, the airdrops with more heat.
• For more heat spread, there are also chips with an aluminum mid plate and attached bath tape at the bottom.
• There is also an under-display Fingerprint sensor on the back of the head.
• It is a thin barrier that takes up some space.
• Proximity sensors and the brightness Sub-display also appear at the bottom of the screen.

Pixel 6 Pro mm-wave Antenna:

Thus, Videos show that the Pixel 6 Pro has a Lever engine on the top of the phone. While the Pixel Pro has a Lever engine on the top. The mm-wave antenna is shown to be positioned on the top edge of the Pixel for the seats and the passengers that support it.

• Thus, For areas where 2000 views are not available, placeholder animations are filled with metal blocks.
• Mm-Wave 5G phones are said to achieve high download speeds, but only one problem arises.
• Qualcomm suggests that Hands Down invests heavily in landscape mode mobile and that the signal is better when used with a 2005 phone with four antennas.
• With a single badly installed Wave 2000 antenna. It is not yet clear whether the Pro 6 will be able to capture high-level communications.
• In terms of repair capabilities, PBK Reviews Reports a USB Type-C port for welding the motherboard, making repairs more difficult.
• The video shows everything coming together under the phone’s waterproof perceptions.

According to the video, there was no problem switching the screen. But the calibration software had to be run to replace the fingerprint sensor, so the phone had to be installed in the factory. Pixel and Pro disassembly videos can be viewed below: